3Racing Sakura D4 Rear Lower Suspension Arm SAK-D4805/BK  [SAK-D4805/BK]

3RACING Sakura D4 Aluminum Rear Lower Suspension - SAK-D4805/BK
Price:
USD$22.70
Brand:
3Racing
Model:
SAK-D4805/BK
Condition:
Brand New
Write a review

Race-Oriented Rear Lower Arm for Sakura D4 Chassis

The 3Racing Sakura D4 Aluminum Rear Lower Suspension Arm is specified for racers who prioritise consistent rear geometry under lateral loads. It replaces the standard plastic arm to reduce deflection and sustain setup settings through multiple runs.

Setup and Tuning Benefits

An aluminium lower arm offers firmer pivot points which aid repeatable toe and camber behavior during drifting. Use this arm to refine tune changes with more predictable feedback when altering camber links or toe settings.

Compatibility, Fitment and Service Tips

Manufactured to match Sakura D4 mounting dimensions, the arm installs with the stock hardware in most configurations. For best results, verify hinge pin wear and torque fasteners to spec after initial installation, then recheck after a short break-in run.

Does this arm require different hinge pins or bearings?

In most cases stock hinge hardware is compatible. If you run reinforced pins or upgraded bearings, check for correct clearance and alignment during installation.

How does the SAK-D4805/BK affect tuning adjustments?

Expect reduced flex at the rear which makes tuning changes more immediate. Small incremental adjustments to toe and camber are advised to dial in handling after the swap.

Recommended inspection routine for competitive use?

Inspect mounting interfaces and fastener torque before each event and look for deformation after contact incidents. Replace the arm if any structural compromise is detected.