3Racing SAK-F50A Front Graphite Shock Tower Stiffer Technical Upgrade  [SAK-F50A]

3RACING Sakura FF Front Graphite Shock Tower Stiffer for FF2014/V2 - SAK-F50A
Price:
USD$7.60
Brand:
3Racing
Model:
SAK-F50A
Condition:
Brand New
Write a review

Track-focused front reinforcement

The 3Racing Sakura FF Front Graphite Shock Tower Stiffer, SAK-F50A, is produced for drivers targeting tighter front-end control on the Sakura FF2014/V2. The graphite construction raises torsional rigidity at the shock mounting area, delivering more consistent geometry under load.

Tuning impact and setup notes

Fitting this stiffer typically sharpens turn-in and reduces progressive compliance at the nose, which affects damping and anti-dive behaviour. Expect to re-evaluate shock oil weight and spring rates when integrating this part into a race setup.

Fitment and installation guidance

SAK-F50A matches the Sakura FF2014/V2 attachment points for a direct swap. During installation, verify screw lengths and torque to avoid point loading. Test incremental setup changes on the practice track to identify optimal balances between front stiffness and overall grip.

How should I adjust damping after fitting the SAK-F50A?

Begin with your baseline settings and reduce front compression damping incrementally if turn-in becomes too abrupt; small changes of 5 to 10 percent help find the correct balance.

Can this part be combined with chassis bracing upgrades?

Yes, combining with controlled bracing can fine tune flex distribution, but adjust one change at a time to isolate effects on handling.

Any fitment tips to avoid stress concentrations?

Use correct screw sizes and avoid over-tightening. Inspect mating surfaces for burrs and ensure even contact to minimise stress risers in the graphite.