3Racing SAK-F52/V2 Rear Graphite Shock Tower 4mm - Racing Setup Component  [SAK-F52/V2]

3RACING Sakura FF Rear Graphite Shock Tower Plus 4mm For FF2014/V2 - SAK-F52/V2
Price:
USD$15.10
Brand:
3Racing
Model:
SAK-F52/V2
Condition:
Brand New
Write a review

Technical Rear Mount Upgrade for Sakura FF2014/V2

The 3Racing Rear Graphite Shock Tower SAK-F52/V2 is produced as a 4mm graphite top plate to improve rear mount stiffness on the Sakura FF2014/V2 chassis. Its stiffer mounting surface reduces unwanted deflection for more repeatable suspension behaviour during competitive use.

Performance and Tuning Notes

For racers focusing on setup consistency, the SAK-F52/V2 gives a firmer anchor point for shocks and link geometry. Expect clearer feedback when making damping or anti-squat adjustments, helping to fine tune rear traction and rotation characteristics.

Installation and Fitment Details

The part is intended to bolt into the Sakura FF2014/V2 standard mounting points. Installation is straightforward and it integrates with existing hardware, though teams may wish to verify fastener torque and recheck alignment after initial track runs.

How does the SAK-F52/V2 affect suspension tuning?

The increased top mount stiffness reduces chassis-induced variables, so damping and spring changes translate more directly to handling adjustments, aiding quicker setup iterations.

Is any chassis modification required?

No chassis modification is expected for correct SAK-F52/V2 fitment on Sakura FF2014/V2 units; the component uses stock mounting positions for a plug-in upgrade.

What should a team check after fitting this tower?

After fitment verify shock alignment, confirm screw torque, and perform a short test run to validate that rear geometry and damping deliver the intended handling response.