3Racing Sakura M4 Pro Graphite Rear Shock Tower - SAK-M4P09  [SAK-M4P09]

3Racing Sakura M4 Pro Rear Gaphite Shock Tower - SAK-M4P09
Price:
USD$11.40
Brand:
3Racing
Model:
SAK-M4P09
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Technical Overview of the SAK-M4P09 Rear Shock Tower

The 3Racing SAK-M4P09 is a purpose made graphite rear shock tower for the Sakura M4 Pro chassis, designed to increase the stiffness of the shock mounting plane and reduce mount deflection under load. The graphite material is selected to provide a high modulus of elasticity while keeping mass low for improved dynamic response.

Material and Performance Notes

Graphite delivers a predictable stiffness profile preferred in race tuning where repeatable suspension behaviour is required. This tower maintains shock geometry to allow precise setup adjustments and consistent handling characteristics lap after lap.

Fitting Procedures for Tuning

Install the SAK-M4P09 with correct torque settings and use thread locker where appropriate on critical fasteners. After initial installation perform a bolt torque check and reverify alignment following the first practice runs to ensure setup stability.

What setup changes are typical after fitting this tower?

Expect reduced flex at the rear shock mounts which can allow firmer spring or damper settings without losing mid corner grip; tune progressively and log lap changes.

Are there special inspection points for graphite parts?

Inspect mounting holes and surrounding areas for delamination or edge chipping, and confirm fastener threads remain undamaged after heavy use.

Can this tower be used in high downforce setups?

The increased stiffness of the SAK-M4P09 supports higher load environments, but always validate through progressive testing when modifying aero or suspension loads.