3Racing SAK-U324/PK 7075 Aluminum Front Suspension Mount  [SAK-U324/PK]

3RACING Sakura Ultimate 7075 Aluminum FF Suspension Mount 1.5 Degree - SAK-U324/PK
Price:
USD$7.60
Brand:
3Racing
Model:
SAK-U324/PK
Condition:
Brand New
Write a review

Precision Racing Mount for Consistent Geometry

The 3Racing Sakura Ultimate 7075 Aluminum FF Suspension Mount at 1.5 degrees is specified for competitive setups that demand repeatable handling. Manufactured to tight tolerances, the 7075 alloy improves front-end stiffness while limiting weight penalty, ensuring predictable response during tuning cycles and race conditions.

Material Performance and Tuning Benefits

7075 aluminium offers high yield strength and fatigue resistance compared to softer alloys, allowing racers to push suspension settings with reduced risk of component distortion. The rigid mount stabilises pivot points for more reliable camber and steering behaviour under load.

Compatibility and Installation Notes

Intended for the Sakura Ultimate chassis, fitment is direct with original mounting points. Racers should verify alignment, torque settings and steering linkage geometry after installation to fully exploit the 1.5-degree configuration for precise corner entry and balance adjustments.

What setup checks are essential after fitting SAK-U324/PK?

Confirm fastener torque, inspect alignment of steering blocks and uprights, and re-establish baseline camber and toe so suspension geometry matches your race setup.

How does the 7075 part affect tuning range?

Increased front-end stiffness narrows uncontrolled flex, giving more predictable results when adjusting roll centres, camber curves and steering bite.

Any special maintenance for aluminium mounts?

Periodic inspection for stress fractures and fastener integrity is advised; clean contact faces and use recommended torque to prevent fretting under race loads.