3Racing Sakura Zero 46mm Universal Shaft - SAK-40A Competition Swing Shaft  [SAK-40A]

3RACING Sakura Zero 46mm Swing Shaft - SAK-40A
Price:
USD$7.60
Brand:
3Racing
Model:
SAK-40A
Condition:
Brand New
Write a review

Race-Grade Drive Shaft for Sakura Zero

The 3Racing Sakura Zero 46mm Universal Shaft - SAK-40A is produced to provide repeatable engagement and reduced backlash for Sakura Zero chassis. The part is suitable for drivers trimming setups where driveline consistency affects lap times.

Precision Fit and Reduced Backlash

This 46mm shaft is finished to tight tolerances to minimise play in the driveline and improve transient response. Consistent spline engagement leads to sharper throttle response and steadier corner exit behaviour.

Integration and Setup Notes

When fitting the 3Racing Sakura Zero 46mm Universal Shaft - SAK-40A inspect spline fit and fastener torque as part of your setup routine. It integrates with standard Sakura Zero components and is a straightforward upgrade for fine tuning handling balance.

What effect does a tighter shaft have on setup tuning?

A shaft with reduced play reveals suspension and steering subtleties, which can require small trim or shock damping adjustments to optimise balance.

Are there any break-in procedures recommended?

Verify fitment, apply recommended light lubrication to splines, and perform low speed runs to confirm engagement before full race loads.

What should I check after installation?

Check spline alignment, fastener torque and bearing condition; confirm there is no binding through the suspension travel to ensure consistent performance.