3RACING 3RAC-WX12SP Wheel Adaptor Spacer Set - Racing Setup  [3RAC-WX12SP]

3RACING Wheel Adaptor Spacer Set - 3RAC-WX12SP
Price:
USD$2.50
Brand:
3Racing
Model:
3RAC-WX12SP
Condition:
Brand New
Write a review

3RACING 3RAC-WX12SP Technical Overview

The 3RACING Wheel Adaptor Spacer Set (3RAC-WX12SP) is designed for competitors and tuners who need repeatable offset adjustments to refine handling balance. This spacer set supports fine-tuning of track width and tyre clearance for track specific setups.

Competitive Use and Compatibility

These spacers complement a wide variety of 1/10 scale race chassis and wheel hubs, allowing quick changes between setups. Use measured spacer increments to alter roll centre and leverage points, and to adapt a single car across different circuit conditions.

Fitting Protocol

Install spacers with progressive, even torque across all wheels to maintain concentricity. Verify spacer seating and wheel runout after installation and retorque following an initial test session. Regular inspection helps maintain consistent handling and reduces the risk of side load induced wear.

How do spacers affect track width and handling?

Adding spacers increases track width which can improve lateral stability but may alter turn-in and midcorner balance; adjust incrementally and log changes for comparison.

What checks should I perform after fitting for race use?

After fitting, check wheel runout, spacer seating, and wheel nut torque. Reinspect after a short run and before each race to ensure repeatable performance.

Are there limits to spacer thickness for safe racing?

Excessive offset increases bearing and axle loads; use conservative spacer stacks and monitor for increased wear when making large changes.