Aftermarket Aluminium Suspension Mount 415-01/1XC by 3Racing  [415-01/1XC]

Tamiya TA05-R /TRF415 /TRF-416 Aluminium Suspension Mount (1XC) - 3Racing 415-01/1XC
Price:
USD$5.00
Brand:
3Racing
Model:
415-01/1XC
Condition:
Brand New
Write a review

Technical summary

The 415-01/1XC aluminium suspension mount is engineered as a single-piece replacement pickup compatible with TAMIYA TA05-R, TRF415 and TRF-416 mounting patterns. Machined geometry provides a consistent hardpoint for suspension linkages and helps reduce deformation under load.

Installation guidance: fit into the factory suspension layout, ensuring correct screw engagement and torque. Use calibrated hand tools to avoid over-torquing and verify alignment and clearance during bench checks.

Tuning notes: the switch from plastic to aluminium increases local stiffness at the suspension pickup which changes transient response and tuning sensitivity; expect to refine damper and roll settings when integrating this mount into a tuned setup.

What are the critical checks after fitting?

Verify screw torque, thread engagement and that the pickup sits flush with the suspension arm. Check for binding across the operating range.

Should I change hardware when swapping to aluminium?

Retain factory fasteners if they match length and thread, but replace any worn screws and use threadlocker where recommended for competition use.

What tuning adjustments are commonly needed?

Expect to fine tune damping and anti-roll settings to account for the increased pickup stiffness; log changes and test progressively.