Auper D6 ARS mount SAK-D6808D/BU - blue aluminium by 3Racing  [SAK-D6808D/BU]

Price:
USD$10.00
Brand:
3Racing
Model:
SAK-D6808D/BU
Condition:
Brand New
Write a review

Replacement ARS linkage mount details

This aluminum ARS linkage mount is a direct replacement hop-up crafted for the Auper D6 1/10 scale RC chassis. It recreates the ARS mounting interface to let users vary link lengths and lateral placement without altering primary suspension arms.

Fitting is performed by removing the stock linkage mount and installing this aluminium unit in the identical position on the Auper D6 chassis, then reattaching the steering linkage and checking neutral steering. The aluminium construction provides a stiffer mounting surface than typical plastic pieces and can help minimize play at the linkage pivot.

Tuning approach: use the ARS mount for incremental tie-rod length and lateral offset adjustments to study effects on steering bite and transient response. Systematic logging of adjustments will reveal how the Auper D6 setup responds over multiple test runs.

Is this a direct-fit replacement for the stock mount?

Yes, it is designed to replace the stock ARS linkage mount on the Auper D6 chassis and uses the same mounting locations for a direct swap.

Will the aluminium change steering feel significantly?

The aluminium mount can reduce flex at the pivot and therefore tighten steering feel; results depend on existing setup and should be validated with controlled tuning steps.

Any advice for initial testing after fitment?

Start with a baseline run, then change one ARS variable at a time. Note handling changes and recheck mount torque and clearance after the first session.