Auper D6 Ball End & Turnbuckle Set SAK-D6807D by 3Racing  [SAK-D6807D]

Ball ends and turnbuckles for replacement and tuning

This 3Racing SAK-D6807D set supplies ball ends and steel turnbuckles intended for use on the Auper D6 RC chassis, serving as direct replacement components for steering and suspension linkage points.

The kit's steel turnbuckles provide a durable threaded connection for toe and camber linkages, while the ball ends allow articulation that reduces binding under suspension travel. Use these parts when replacing worn linkage hardware or when you need predictable adjustment range during setup changes.

Installation is straightforward: remove the existing linkage at the ball end or turnbuckle, fit the replacement ball end onto the linkage rod or servo horn, and thread the turnbuckle to obtain the required length and alignment. Check thread engagement and locking method after adjustment to prevent loosening during running.

Tuning notes: small incremental adjustments to turnbuckle length change toe and camber subtly, affecting corner entry and mid-corner balance; make changes one at a time and verify handling on track before further alterations.