Auper D6 Steering Rack Replacement Bolt SAK-D6805A by 3Racing  [SAK-D6805A]

Price:
USD$3.80
Brand:
3Racing
Model:
SAK-D6805A
Condition:
Brand New
Write a review

SAK-D6805A steering bolt for Auper D6 explained

The SAK-D6805A is a steering rack bolt sized for the Auper D6 chassis and intended to serve as a direct replacement for the factory fastener. It secures steering linkage points and supports accurate trim without changing the rack geometry.

Titanium construction offers a favorable strength-to-weight ratio and improved corrosion resistance compared with untreated steel fasteners, helping maintain consistent link positions in routine hobby use.

Installation guidance: follow the chassis service steps to remove the rack, transfer any bearings or spacers, insert the SAK-D6805A through the rack and linkage, and tighten to the recommended torque. Verify steering travel and fine tune using the servo saver or turnbuckles to remove any residual play.

Use this bolt for maintenance replacement or when upgrading to a material that extends service life while preserving steering characteristics.

Can the SAK-D6805A be used as a direct swap on the Auper D6?

Yes. It is designed to match the Auper D6 steering rack dimensions. Install it in the same orientation as the original bolt and check link clearances before final torque.

What routine checks should I do after fitting the bolt?

Periodically inspect the bolt for secure seating, check bearing and ball end wear, and confirm that steering travel remains free and centered. Re-torque if necessary after initial running.

Are there any precautions when combining with other metals?

Titanium can behave differently when in contact with certain metals; use recommended lubrication on threads where specified and avoid mixing incompatible alloys in high-friction interfaces.