Auper D6 Upper Deck Upgrade SAK-D6808E/BU by 3Racing  [SAK-D6808E/BU]

Price:
USD$7.50
Brand:
3Racing
Model:
SAK-D6808E/BU
Condition:
Brand New
Write a review

Upper deck mount for Auper D6

This aluminium upper deck mount is built to fit the Auper D6 chassis and is identified by model SAK-D6808E/BU. It is offered as an aftermarket upgrade to alter chassis stiffness and provide a firmer mounting plane above the main rails.

The component acts as a structural link between suspension and bulkhead areas to influence torsional behavior while retaining suspension geometry. Use it to refine mid-corner balance or to limit chassis flex during braking and acceleration on 1/10 electric RC vehicles.

Installation notes: the mount replaces the stock upper deck in the Auper D6 arrangement and locates to existing mounting points. Check alignment and that fasteners run in smoothly before final tightening to avoid deck distortion or incorrect suspension pickup alignment. This information refers solely to the RC accessory.

Can this part be used on other chassis shapes?

The design targets the Auper D6 mounting pattern. It may fit similar layouts, but verify hole positions and clearances before ordering for a different chassis.

What should I inspect after a hard impact?

After impacts, inspect the deck for bends, cracked fixings, or loose fasteners. Replace damaged screws and check that the deck still seats flat against the chassis rails.

Does the deck affect tuning approach?

Yes. Because it changes torsional stiffness, expect to revisit damper and spring settings to restore the desired balance. Make incremental adjustments and log results to find the best setup.