AX10 Scorpion Precision Motor Plate 28mm AX10-16 by 3Racing  [AX10-16]

AXIAL AX10 Scorpion Chassis 28mm Brushless Motor Plate - 3RACING AX10-16
Price:
USD$5.00
Brand:
3Racing
Model:
AX10-16
Condition:
Brand New
Write a review

Precision motor plate for AX10 Scorpion tuning

This plate is engineered for the AX10 Scorpion chassis to accept 28mm brushless motors and provide a consistent datum for motor-to-spur alignment, enabling repeatable gear mesh during iterative setup and testing.

Assembly is a bench-fit procedure: position the motor, verify pinion engagement with the spur, then secure fasteners while checking axial and radial clearance to the servo and ESC. Use fine shims or micro adjustments to control backlash and achieve a low-noise mesh. Confirm correct screw length and thread engagement with the chassis bosses to avoid preload issues.

From a tuning standpoint, AX10-16 allows controlled motor offset changes without modifying gearbox elements. Small offset shifts change load distribution and acoustic signature, so validate setup with short loaded cycles and monitor thermal behaviour rather than relying solely on static checks.

How does this improve gear alignment repeatability?

The plate establishes a fixed motor mounting datum so motor location can be reproduced precisely between builds, helping to maintain consistent pinion to spur engagement across setups.

What adjustments give the best balance of noise and longevity?

Use minimal shim thickness to eliminate lash while avoiding excessive preload. Validate under short loaded runs and monitor gear temperature to balance quiet operation with reduced wear.

Any hardware recommendations for secure mounting?

Select screws sized to your chassis threads with sufficient engagement length. Avoid bottoming out and verify torque to prevent motor shift under load.