AX10 Scorpion Race-Focused Motor Heat Sink Plate - AX10-07/GR by 3Racing  [AX10-07/GR]

AXIAL AX10 Scorpion Chassis Motor Heat Sink Plate - 3RACING AX10-07/GR
Price:
USD$13.80
Brand:
3Racing
Model:
AX10-07/GR
Condition:
Brand New
Write a review

Performance heat sink for AX10 Scorpion setups

This heat sink plate is configured to align with AX10 Scorpion motor bays and is supplied as model AX10-07/GR. It provides additional metal surface area to assist passive heat transfer from the motor during sustained low-speed, high-load operation.

Intended as a lightweight, non-invasive upgrade, the plate increases thermal dissipation without altering gear ratios or driveline geometry. Use it where riders need predictable thermal behaviour under extended crawling or slow-pace trials.

Fit and installation notes: the component targets standard AX10 Scorpion motor footprints. Confirm mount alignment, fastener lengths and clearances to the ESC and steering servo; track any potential interference and use spacers or alternate fastening points if required.

Tuning and setup: integrate the heat sink plate as part of a tuning package focused on thermal stability. It complements ESC configuration and chassis airflow improvements, helping reduce steady-state motor temperature rise in demanding technical conditions.

How should I verify mechanical fit before final mount?

Measure motor mount hole spacing and check the plate against the motor can and gearbox. Trial-fit with the motor installed and rotate the drivetrain to ensure there is no contact.

Will the plate change motor cooling under long runs?

The plate enhances passive surface area which can lower sustained motor temperatures. It is not an active cooler but improves thermal paths when combined with proper ventilation and ESC tuning.

Recommended checks after installation?

After mounting, verify gear mesh, driveline clearance and wiring routes. Monitor motor temperature on a test run and adjust mounting or airflow if hotspots appear.