3RACING AX10-16 AXIAL AX10 Scorpion Motor Plate 28mm  [AX10-16]

AXIAL AX10 Scorpion Chassis 28mm Brushless Motor Plate - 3RACING AX10-16
Price:
USD$5.00
Brand:
3Racing
Model:
AX10-16
Condition:
Brand New
Write a review

Technical Overview for 3RACING AX10-16

The 3RACING AX10-16 brushless motor plate provides a compact mounting interface engineered for 28mm brushless cans on the AXIAL AX10 Scorpion chassis. Its form factor prioritises consistent motor positioning to support repeatable gear mesh under load.

Performance and Setup Use

Designed with racers and tuners in mind, the plate facilitates rapid motor swaps and reliable alignment so that changes in motor KV or torque do not introduce unpredictable drivetrain behaviour. Its compatibility with standard 28mm motors makes it straightforward to test alternative setups.

Installation and Tuning Notes

For best results, secure fasteners incrementally while verifying pinion engagement. Fine tuning may require thin shims to achieve optimal mesh and to prevent axial loading on bearings. Regular checks after initial runs will confirm the assembly remains stable under competition conditions.

How does this plate affect gear mesh consistency?

The plate stabilises motor placement to keep pinion engagement repeatable, reducing variations that can cause premature gear wear during tuning or repeated motor swaps.

Is the plate suitable for quick motor changes during testing?

Yes, the layout supports accessible mounting hardware and common 28mm motor sizes, allowing efficient swaps while maintaining alignment for comparative testing.

Any recommended checks after swapping motors?

After a motor change, verify mounting torque, inspect pinion mesh under rotation, and perform a short low speed run to confirm no binding before full power testing.