AXIAL AX10 Scorpion Racing Driveshaft Cap AX10-10 by 3Racing  [AX10-10]

AXIAL AX10 Scorpion Scorpion Driveshaft Cap - 3RACING AX10-10
Price:
USD$11.30
Brand:
3Racing
Model:
AX10-10
Condition:
Brand New
Write a review

Technical Notes on Driveshaft Cap

This driveshaft cap is specified for the AXIAL AX10 Scorpion platform under the AX10-10 part code and is engineered to locate the driveshaft interface without altering axle geometry. It is intended as a direct-fit replacement for standard housings.

The cap secures the driveshaft termination and maintains axial alignment between the shaft and housing under dynamic loads. Correct seating reduces endplay and contributes to consistent driveline behavior during competitive use.

For installation, verify spline engagement and bearing clearances, reuse high-quality fasteners or fit equivalent-grade replacements, and perform a slow rotation check to confirm no binding before final torque. Regular inspection after high-stress runs will help preserve tolerances and component life.

What should I measure before fitting?

Measure axle face-to-fastener distances and verify spline engagement depth to ensure the AX10-10 cap seats correctly on your axle housing.

Recommended fastener practice?

Use clean, undamaged fasteners torqued incrementally to spec. Replace any stretched or corroded screws to maintain clamp load and prevent loosening under load.

How to verify reduced driveline lash?

With the cap fitted, cycle the drivetrain and measure endplay under light load. Reduced axial movement and smooth rotation indicate proper seating and alignment.