DF-03 Graphite Rear Shock Tower DF03-06/SG by 3Racing  [DF03-06/SG]

Tamiya DF-03 SSG Graphite Rear Shock Tower - 3RACING DF03-06/SG
Price:
USD$18.30
Brand:
3Racing
Model:
DF03-06/SG
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Technical rear shock tower for DF-03

Precision graphite rear shock tower engineered for the TAMIYA DF-03 platform and compatible Dark Impact body arrangements. The component stiffens the rear shock upper mounting area to reduce local compliance during high load events and hard landings.

Functionally the unit is a tuning element: decreasing deflection at the shock anchor changes force transmission through the rear end and allows for more consistent traction and transient response when iterating setup.

Installation is direct on DF-03 chassis that retain the OEM rear tower bosses; remove the factory tower, transfer any necessary spacers or screws, and secure the graphite unit to the existing bosses. No supplemental hardware is included.

Specifications

  • Item: Rear shock tower
  • Material: Graphite
  • Model Number: DF03-06/SG
  • Compatibility: Tamiya DF-03 chassis, Tamiya Dark Impact

Compatibility and use

Confirm standard DF-03 rear shock mount layout prior to fitting. The tower is intended for hobbyists and tuners seeking a stiffer rear anchor for improved setup consistency.

The graphite upgrade provides a compact, low-mass solution to stiffen the rear shock mounts and enhance repeatable suspension response.

What mounting points must be unchanged for fitment?

The rear tower requires the stock DF-03 rear shock tower boss positions. Any chassis modification that shifts those bosses will prevent proper fitment.

Does the part affect roll centre or camber?

The tower primarily reduces local flex at the shock anchors; it does not directly change suspension geometry, but chassis stiffness changes can influence on-track roll behaviour.

Recommended setup changes after installation?

Tuners commonly reduce rear damping or soften springs slightly to compensate for the firmer anchor and maintain desired transient and traction characteristics.

Is any machining or trimming required?

No machining is expected for standard DF-03 layouts; the part installs with existing mounting hardware and bosses.