FF-03 Graphite Radio Tray FF03-18/WO by 3Racing  [FF03-18/WO]

High-performance graphite radio tray for FF-03 platforms

The FF03-18/WO graphite radio tray is manufactured to match the Tamiya FF-03 chassis mounting footprint and to provide a stiffer, low-deflection platform for the receiver and radio components. The geometry preserves factory screw locations while increasing local torsional rigidity.

Constructed to benefit chassis feedback in competitive touring setups, the tray replaces the OEM platform without cosmetic alteration. The graphite surface reduces micro-movement under lateral loads, helping maintain consistent electronics placement during dynamic cornering and braking events.

Installation follows standard FF-03 service procedures: remove the stock tray, align the replacement to the chassis bosses, and refit using the original fasteners. Typical hex drivers used for FF-03 assembly are sufficient for secure mounting.

From a setup and tuning viewpoint the part functions as a discrete stiffness tunable point. Swapping to this firmer platform can shift handling balance and response; validate changes with measured test laps and fine tune suspension or trim settings as needed.