FW05-R/FW05RR Graphite Steering Plate FW05-011 by 3Racing  [FW05-011]

Technical overview of the graphite steering plate

This graphite steering plate is an RC-scale replacement developed for Kyosho FW05-R and FW05RR chassis and identified as FW05-011. It is engineered as a direct-fit upgrade to increase front-end structural stiffness and provide more consistent steering input transfer while preserving the chassis' original geometry.

Installation requires standard model assembly procedures: remove the factory steering plate, position the graphite plate using the existing mounting points, and secure with the original fasteners, then verify servo horn and linkage clearance prior to dynamic testing. No chassis modification is required for correct fit on compatible FW05-R or FW05RR configurations.

From a tuning standpoint the graphite component reduces compliance in the steering stack, sharpening steering response and improving feedback under lateral load. This upgrade is suitable for racers and tuners aiming to refine turn-in character or adjust understeer/oversteer balance via front bulk stiffness rather than suspension or tyre changes. Routine inspection for fine surface defects and confirmation of fastener torque are recommended maintenance steps.