FW05-RR004 Graphite Radio Tray for Kyosho FW05RR - Tuners Edition by 3Racing  [FW05-RR004]

Kyosho FW05RR Graphite Radio Tray - 3RACING FW05-RR004
Price:
USD$22.90
Brand:
3Racing
Model:
FW05-RR004
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

3Racing FW05-RR004 graphite tray for FW05RR setups

Precision-cut graphite tray to secure receiver and ancillary electronics in FW05RR radio bays, providing a stiff platform that supports repeatable handling and tuning changes. The low mass and rigidity help preserve chassis balance while allowing close component placement for optimal cable routing.

Intended as a direct replacement for the stock radio plate, the tray concentrates wiring and small modules to streamline setup changes between runs. Clear routing paths reduce clutter and speed component swaps during race day adjustments.

Install using the FW05RR radio bay mounting points: align and fasten with the original screws, then route antenna and power leads to avoid proximity with steering and suspension pivots. Confirm servo and ESC clearance before final torque to keep service access during pit work.

Specifications

  • Item: Radio tray
  • Material: Graphite
  • Model Number: FW05-RR004
  • Brand: 3Racing
  • Compatibility: Kyosho FW05RR

For competitive FW05RR tuning the FW05-RR004 tray provides a compact, stiff mounting surface that improves wiring management and shortens setup time between runs.

What mounting tolerance should I expect?

The tray is machined to match FW05RR radio bay dimensions; minor chassis tolerances may require alignment shims or slight repositioning before final fastening.

Recommended fastening torque?

Use the OEM fasteners and tighten to a snug fit without over-torquing; graphite can crack if bolts are overtightened.

Any shielding or isolation needed?

Isolate bare circuit boards from the graphite using foam or insulating tape to avoid conductive contact. Maintain antenna separation from grounded parts for reliable reception.

Will the tray help with quick swaps between setups?

Yes, the organised layout and stable mounting points make receiver reinstallation and small adjustments faster during setup cycles.

Is additional reinforcement required for heavy components?

For heavier modules consider local reinforcement or secure tie-downs; the tray is optimised for receiver and small electronics rather than large batteries.