3Racing FW06-16 Front Shock Tower for Kyosho FW-06 - Race Setup Part  [FW06-16]

Kyosho FW-06 Front Shock Tower - 3RACING FW06-16
Price:
USD$8.90
Brand:
3Racing
Model:
FW06-16
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Race focused front structure for Kyosho FW-06

The 3Racing FW06-16 Front Shock Tower for Kyosho FW-06 is a performance replacement designed to deliver consistent front geometry under load. Its development targeted improved torsional resistance so setup changes translate predictably to handling.

Technical advantages for tuning

Built with an emphasis on structural stiffness and repeatability, this tower reduces variables caused by body flex. That makes it easier to compare changes in spring rates, damping and anti-roll tuning during setup sessions.

Installation and compatibility notes

Intended for direct fit on Kyosho FW-06 chassis layouts, the tower retains original mounting points to preserve established alignment settings. Fitment is straightforward and it is recommended to recheck baseline geometry after installation.

What setup differences should I expect after installation?

Expect a firmer front end with crisper turn-in. You may need to soften springs or increase front toe to fine tune initial bite at the limit.

Is the tower suited to high downforce or low downforce setups?

The increased stiffness benefits both setups by delivering stable geometry; tuning of dampers and anti-roll bars will determine exact front behaviour under different aerodynamic loads.

Any specific installation torque or fixture advice?

Use the chassis manufacturer recommended torque for mounting screws and check for even contact across mounting faces. Periodic checks after running are advised to catch any loosening.