Kyosho Mini Inferno Graphite King Pin Holder Upgrade - MIF-024/WO by 3Racing  [MIF-024/WO]

Kyosho Mini Inferno /Kyosho Mini Inferno ST Graphite King Pin Holder Set (2 pcs) - 3Racing MIF-024/WO
Price:
USD$5.70
Brand:
3Racing
Model:
MIF-024/WO
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Performance graphite king pin holders

This graphite king pin holder set is supplied for Kyosho Mini Inferno and Mini Inferno ST chassis and carries model number MIF-024/WO. The two-piece graphite design offers a stiffer, lightweight mounting solution to reduce pivot compliance and maintain king pin alignment under lateral load.

These holders are a direct replacement for the OEM items and are intended to preserve original suspension geometry while delivering improved steering stability. Installation is performed by replacing the stock holders and retaining the existing knuckle hardware where appropriate.

For setup work, expect more consistent toe and Ackermann behaviour when compared to flexible holder materials. Check fastener torque and inspect contact faces during installation to ensure repeatable performance on the track.

What material properties does the graphite offer?

Graphite provides a balance of low flex and low weight, helping to stabilise the king pin without adding significant mass to the steering assembly.

Will these change alignment settings?

They are designed to maintain the stock geometry; any perceived alignment change is typically due to reduced deflection at the king pin rather than a shift in mounting points.

Recommended inspection after fitting?

Verify secure fastening and check for even contact at the king pin face. Reinspect after a few runs to confirm there is no unexpected wear or loosening.