Kyosho Mini Inferno Half8 Rear Swing Shaft MIF-022/BU by 3Racing  [MIF-022/BU]

Kyosho Mini Inferno Rear Swing Shaft( 1 pairs ) Half8 - 3RACING MIF-022/BU
Price:
USD$11.30
Brand:
3Racing
Model:
MIF-022/BU
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Technical rear swing shaft overview

This rear swing shaft is supplied as a 1 pcs pair for the Kyosho Mini Inferno Half8 chassis and is identified by model MIF-022/BU. It is designed as a direct replacement for the rear swing linkage and is suitable for precise suspension rebuilds and setup adjustments.

Intended use is to restore correct rear geometry or replace fatigued linkage components during maintenance. The shaft locates into the rear hub and suspension arm assembly, so confirm Half8 compatibility prior to fitment. This component is aimed at reliable service and repair rather than altering dynamic performance characteristics.

Fitment procedure: remove the rear hub assembly, inspect bearings and mounts for wear, install the shaft ensuring square alignment, confirm smooth rotation through the suspension travel, and secure fasteners to factory torque settings. Use calibrated tools for repeatable results.

What chassis does MIF-022/BU support?

Specifically produced for the Mini Inferno Half8 rear layout; cross-check your chassis code and rear arm geometry before installing.

Is this supplied as a pair or single item?

The listing provides the rear swing shaft as a 1 pcs pair, intended to replace both left and right linkage shafts during a service.

Any recommended checks during installation?

Verify bearing condition, ensure no lateral play at mounting points, confirm alignment through full suspension travel, and use the vehicle makers torque values for fasteners.