Kyosho Mini Inferno ST 64 Racing Slipper Shaft MIF-014 by 3Racing  [MIF-014]

Kyosho Mini Inferno ST 64 Titanium Slipper Gear Shaft - 3RACING MIF-014
Price:
USD$7.50
Brand:
3Racing
Model:
MIF-014
Condition:
Brand New
Write a review

Racing-grade titanium slipper shaft for Mini Inferno ST 64

The MIF-014 titanium slipper gear shaft is a purpose-built replacement aimed at drivers seeking stiffer shaft behaviour and consistent spur engagement in Kyosho Mini Inferno ST 64 setups. As the rotating axle for the slipper assembly, it carries the spur and transfers pinion torque while allowing controlled slip when the slipper is deployed.

Intended as a direct service swap for Mini Inferno ST 64 platforms, installation requires checking the slipper plate and friction medium, reusing precise shims and spacers, and ensuring axial spur alignment to preserve correct mesh and endplay. Accurate reassembly is key for predictable race performance.

In tuning terms, the titanium shaft reduces bending and improves repeatable alignment under load, supporting tighter gear mesh and sharper drivetrain response without altering the slipper's calibrated slip curve. Fit as part of a setup focused on durability and consistent lap times.

How does this shaft support race setups?

By limiting axial deflection and maintaining spur alignment under torque, the shaft helps keep gear mesh consistent during aggressive throttle inputs, which is beneficial for repeatable lap times.

What assembly practices ensure best results?

Reinstall original shims and spacers accurately, verify spur axial position, and set slipper tension carefully. Small mesh adjustments and test runs will reveal the optimal setup for your track conditions.

Is this suitable for high power motors?

Yes, the increased stiffness and wear resistance of titanium helps the shaft resist bending under higher torque, but ensure the rest of the drivetrain is rated for the motor's output.