Kyosho Mini Inferno / Mini Inferno ST 1 Degree Rear Suspension Holder MIF-026/TI by 3Racing  [MIF-026/TI]

Technical summary

The MIF-026/TI rear suspension holder is a compact replacement part for Kyosho Mini Inferno and Mini Inferno ST chassis that provides a 1 degree rear offset to alter toe geometry. Finished in a titanium colour, the component is intended for careful setup adjustments rather than structural enhancement.

Functionally the holder makes a small change to rear geometry to influence toe angle, allowing experienced drivers to fine-tune corner entry and mid-corner stability on micro on-road surfaces. It mounts to the stock rear points of the Mini Inferno platform and is presented as a direct-replacement component.

Installation is a standard swap: remove rear linkage hardware, fit the MIF-026/TI holder with original fasteners, ensure correct thread engagement and torque, then verify alignment and wheel tracking before test running. After initial laps re-evaluate ride height and toe and proceed with conservative tuning steps.

Tuning notes: expect subtle handling shifts from a 1 degree rear offset, typically small gains in rotation or rear bite. Use this holder when incremental toe correction is required to refine balance without disruptive handling changes.