3Racing MIF-046/WO Graphite Servo Plate for Kyosho Mini Inferno ST  [MIF-046/WO]

Kyosho Mini Inferno /Kyosho Mini Inferno ST Graphite Steering Servo Plate - 3Racing MIF-046/WO
Price:
USD$6.30
Brand:
3Racing
Model:
MIF-046/WO
Condition:
Brand New
Write a review

Racing-Grade Graphite Servo Mount

The 3Racing Graphite Steering Servo Plate MIF-046/WO is engineered as a low-deflection mounting solution for Kyosho Mini Inferno and Mini Inferno ST platforms. Its stiff graphite construction improves the mechanical transfer between servo output and steering linkage, aiding consistent lap times.

Enhanced Mount Rigidity for Setup Precision

Replacing the OEM plate with this graphite unit reduces torsional and bending flex at the servo interface, allowing tighter steering calibration and more predictable balance during aggressive cornering. This supports finer trimming and setup adjustments for competitive running.

Direct Fit and Minimal Installation Time

The component aligns to Kyosho Mini Inferno factory holes for a direct replacement that requires no chassis modification. Use existing hardware where applicable and validate fastener length to avoid compressive stress on the graphite surface.

How does the MIF-046/WO affect steering tuning

The reduced flex from the graphite plate lets you tune servo travel and steering rates with greater repeatability, improving consistency between setup runs.

Any special mounting considerations for race setups

Confirm screw length and torque to avoid stress concentrations in the graphite. For competitive use, inspect mounting hardware regularly and replace stripped screws immediately.

Is there a measurable lap time benefit

While lap time gains depend on driver and setup, the consistent steering input from a low-flex mount reduces variability and can support improved cornering precision for tuned cars.