Kyosho Mini Inferno ST Precision Rear Suspension Holder 2 Degree Offset MIF-027/BU by 3Racing  [MIF-027/BU]

Technical rear mount for Mini Inferno ST tuning

This rear suspension holder is a purpose-built replacement for the Kyosho Mini Inferno ST chassis, identified as part MIF-027/BU. The 2 degree bias integrated into the mounting face provides a calculated rear-arm offset to adjust camber and toe parameters while retaining the base suspension kinematics.

Fitment and role: engineered to supplant the original rear holder, this component modifies rear wheel alignment to support setup refinement. It suits drivers focused on precise handling adjustments on carpet and track surfaces, where small geometry changes are used to fine-tune cornering balance and traction. It is a tuning-specific upgrade rather than a wholesale suspension redesign.

Installation notes: verify hub and linkage clearances before final torque and perform a post-fit alignment check. Adopt incremental shock and toe link adjustments during evaluation so changes are reversible. Confirm full suspension travel remains unconstrained after fitting to avoid binding under load.

Tuning guidance: the 2 degree offset delivers modest but repeatable shifts in turn-in and rear grip behaviour. Use systematic test runs with controlled changes to shock damping and tyre selection, altering only one parameter at a time and logging results for reproducible setup optimisation.