3Racing KZ-06/V2/WO Racing Motor Mount for Kyosho MR-015 Mini-Z MR-02 RM  [KZ-06/V2/WO]

Kyosho Mini-Z MR-015 AL Motor Mount W/ Graphite Plate Ver. 2 For Mini-Z MR-02 RM - 3Racing KZ-06/V2/WO
Price:
USD$12.60
Brand:
3Racing
Model:
KZ-06/V2/WO
Condition:
Brand New
Write a review

Race-Focused Motor Mounting Solution

The 3Racing Kyosho Mini-Z MR-015 AL Motor Mount with Graphite Plate Ver. 2 is specified for the Mini-Z MR-02 RM to provide a precise motor location and reduced compliance under load. It is intended as a tuning component for drivers seeking consistent drive train behaviour.

Engineering and Track Benefits

Aluminium construction offers predictable stiffness while keeping mass low, and the graphite plate serves to damp micro-vibrations at the motor interface. This combination improves repeatability in braking and acceleration zones, aiding consistent lap performance.

Installation Notes for Competitive Setups

Designed to match MR-02 RM mounting geometry, the component installs using existing chassis points. After fitting, verify pinion to spur mesh and ensure fasteners are torqued to maintain alignment during aggressive running.

What setup checks should I perform after fitting this mount?

Confirm pinion to spur gear mesh, check motor axial alignment, and re-torque mounting screws after a few runs to ensure the assembly settles correctly.

Is this suitable for competitive Mini-Z classes?

The mount is built to offer reduced flex and consistent positioning, making it appropriate for club and local competition where predictable drive train response matters.

Any recommendations for fasteners or threadlocker?

Use correct length screws and tighten to firm hand torque. Light threadlocker can be used on fasteners if you run in high vibration environments, but avoid overuse that could complicate future adjustments.