3Racing KZ-14/3/SG Graphite Reinforced Plate for Kyosho Mini-Z MR-015 Ferrari 575 GTC  [KZ-14/3/SG]

Kyosho Mini-Z MR-015 Graphite Reinforced Plate For Mini-Z Car Body (Ferrari 575 GTC) - 3Racing KZ-14/3/SG
Price:
USD$5.00
Brand:
3Racing
Model:
KZ-14/3/SG
Condition:
Brand New
Write a review

Technical Reinforcement for Competitive MR-015 Builds

The 3Racing KZ-14/3/SG graphite reinforcement is engineered to add targeted stiffness to the Kyosho Mini-Z MR-015 chassis while maintaining a low mass footprint. It is shaped to match the Ferrari 575 GTC shell and supports improved chassis behaviour under lateral loads.

Chassis Tuning and Handling Benefits

Constructed from graphite for an optimal stiffness to weight ratio, this plate reduces unwanted flex that can upset balance during corner entry and mid corner. It allows finer suspension tuning and more predictable transient response for drivers refining setup for competitive running.

Installation and Setup Guidance

Installation follows standard MR-015 mounting points and requires basic Mini-Z tools. After fitting, verify clearance for electronics, then perform incremental suspension adjustments to exploit the increased chassis rigidity for lap time improvements.

What is the main tuning effect of this plate?

The primary effect is reduced chassis flex, which translates to steadier turn in and more consistent mid corner behaviour, enabling finer suspension adjustments.

Are there any known fitment conflicts with common MR-015 mods?

Most standard upgrades are compatible, but verify battery and servo clearance where custom mounts or larger components are fitted.

Recommended post-fit checks for optimal setup?

After fitting, check ride height, toe and camber, then run a series of short tests to refine damping and spring rates to match the stiffer chassis characteristics.