Kyosho Mini-Z MR-015 Precision Body Holder KZ-14/4/BU by 3Racing  [KZ-14/4/BU]

Kyosho Mini-Z MR-015 Body Holder For Mini-Z Car Body (Audi A4 DTM 2005) - 3Racing KZ-14/4/BU
Price:
USD$7.50
Brand:
3Racing
Model:
KZ-14/4/BU
Condition:
Brand New
Write a review

Engineered retention for MR-015 bodies

This precision body holder is specified for Kyosho Mini-Z MR-015 shells, matched to the Audi A4 DTM 2005 body referenced in the listing. It provides a consistent interface between the polycarbonate shell and MR-015 chassis to control body location under load.

The component is designed for accurate alignment with MR-015 body posts and supplies a repeatable mounting datum for shell changes. Installation is reversible to enable maintenance or livery changes without chassis modification.

From a setup perspective, use the holder to secure body clearance and reduce shell movement that can affect aerodynamic balance at miniature scale. Confirm post engagement and clearance after installation for predictable fitment across sessions.

How does this ensure repeatable fit?

The holder aligns with standard MR-015 post locations to provide the same seating position every fit, minimising variation between shell swaps and preserving consistent clearance.

Any special installation steps?

Install on a clean chassis, engage all post points, and verify that the shell sits flat with even gaps. Trim only where necessary and avoid altering chassis mounting points.

Recommended checks after fitting?

Confirm body clearance around wheels and steering, inspect for any rubbing on electronics, and perform a short test run to check for movement after impacts.