Kyosho Mini-Z MR-02 (MM) Race-Tuned Graphite H Plate - Soft MZII-001A by 3Racing  [MZII-001A]

Kyosho Mini-Z MR-02 (MM) Graphite H Plate - Soft - 3RACING MZII-001A
Price:
USD$2.50
Brand:
3Racing
Model:
MZII-001A
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Race oriented graphite H plate for Mini-Z MR-02 (MM)

This soft graphite H plate is manufactured for the Kyosho Mini-Z MR-02 (MM) chassis and locates at the MM H plate position. It is offered as a tuning upgrade for competitive hobbyists, not as a structural replacement.

Installation follows the original chassis mounting pattern using existing screws and mounts. Typical toolkit requirement is a small hex driver; no special adapters are necessary. The softer graphite increases compliance at the H plate junction compared with stiffer materials, permitting controlled adjustments to front/rear load distribution and mid corner behaviour while leaving suspension geometry unchanged.

Use this component for methodical setup testing on indoor circuits where small compliance changes can yield measurable lap time or consistency improvements. This part is intended exclusively for RC chassis tuning use.

What setup gains can be expected?

Expect finer mid corner traction control and a slightly different roll response; gains depend on tyre, camber and overall chassis balance when combined with other setup changes.

Is this suitable for competitive tuning cycles?

Yes, the soft graphite plate is intended for iterative setup work on indoor tracks where subtle compliance tuning can help optimise car behaviour over a race programme.

Any installation cautions for race use?

Ensure correct screw torque to avoid crushing the graphite and inspect the plate after impacts. Replace if any delamination or cracks appear to maintain consistent handling.