Kyosho Mini-Z MR-02 (MM) Toe Link Upgrade MZM-004 by 3Racing  [MZM-004]

Technical toe in/out linkage overview

This toe in/out linkage is developed for Kyosho Mini-Z MR-02 (MM) chassis and Mini-Z Monster variants to provide precise control over front toe geometry. It enables targeted changes to steering kinematics that influence initial turn-in, lateral response and mid-corner tracking without altering main suspension assemblies.

Confirm compatibility with Kyosho Mini-Z MR-02 (MM) and Mini-Z Monster series before installation. The linkage is intended as a direct-fit replacement that uses existing steering attachment points and maintains stock mounting geometry.

Fitting procedure: remove the factory toe link, position the replacement in the same mounting holes and secure with the original fixings. Check alignment visually and perform controlled test runs; re-torque connections after the initial session to stabilise geometry under load.

Setup guidance: use incremental toe adjustments and document each step to gauge handling changes. Small changes to toe can refine turn-in responsiveness and high-speed tracking on short indoor circuits; pair toe tuning with trim checks for consistent results.