M05 Rear Hub Carrier CNC-Style Aluminium 2 Degree - M05-30/2/LB by 3Racing  [M05-30/2/LB]

Tamiya M05 Rear Aluminum Hub Carrier (2 Degree) - 3RACING M05-30/2/LB
Price:
USD$11.30
Brand:
3Racing
Model:
M05-30/2/LB
Condition:
Brand New
Write a review

Performance-focused rear hub carrier for M05 setups

This aluminium hub carrier is a purpose-built replacement for the TAMIYA M05 rear carrier, offering a fixed 2 degree offset to deliver predictable rear toe changes during tuning cycles. The machined metal construction reduces flex relative to the stock plastic part and helps maintain consistent geometry over repeated runs.

Installation procedure mirrors stock service steps: remove the existing carrier, relocate bearings and fasteners, and secure the aluminium carrier in the original positions. After fitting, perform alignment checks and validate suspension travel to confirm the applied 2 degree orientation meets your setup requirements.

Use this carrier for controlled test sessions where repeatability matters, such as comparing rear-end balance or dialling in mid-corner traction. The fixed 2 degree angle is a deliberate tuning increment to influence rear tracking and handling characteristics under race conditions.

Does the carrier accept standard M05 bearings?

Yes, the unit is sized for the same bearings and mounting hardware used by the stock M05 rear carrier, allowing reuse of the original components.

What should I inspect after a hard impact?

Check the carrier for cracks or bends, verify bearing seating and fastener torque, and re-align the rear wheels to ensure geometry was not altered by the impact.

Is this recommended for repeat testing and setup validation?

Yes, the aluminium carrier provides stable geometry for iterative testing and is suited to drivers refining handling through incremental rear toe adjustments.