Mini 4WD Carbon Multi Roller Setting Plate M4WD-15_SG by 3Racing  [M4WD-15_SG]

Tamiya Mini 4WD Carbon Multi Roller Setting Plate - 3RACING M4WD-15_SG
Price:
USD$3.80
Brand:
3Racing
Model:
M4WD-15_SG
Condition:
Brand New
Write a review

Technical: carbon multi roller setting plate for Mini 4WD M4WD-15_SG

This carbon setting plate is an aftermarket component for 1/32 Mini 4WD cars, intended to consolidate multiple roller mounting positions on a single, rigid panel. It is made for front, rear or side stay configurations and aimed at competitive hobbyists seeking compact roller layouts.

Constructed from carbon to maximise stiffness-to-weight ratio, the plate features carefully spaced holes and slots to match common roller diameters and spacer stacks used in race setups. The panel allows tighter packaging of roller arrays where traditional stays would be bulky.

Fitment requires attention to screw length, head type and stack height to maintain correct engagement without risking delamination. Use appropriate torque settings and washers when joining carbon to metal stays, and verify clearances under full suspension movement if applicable.

Compatibility is descriptive: intended for use with Tamiya Mini 4WD stay assemblies in front, rear or side positions. Confirm exact physical fit with your stay set and review the seller listing for detailed fitment and included hardware.

What roller diameters and spacer stacks are supported?

Hole spacing is laid out to accept common roller diameters and typical spacer stacks, but confirm specific measurements on the product listing to match your preferred rollers.

Any recommendations for screw type and torque when fitting?

Use low-profile screws that clear bearings and spacers, secure with washers, and apply controlled torque to avoid compressing or cracking the carbon layers.

Will the plate alter ride height or handling?

Consolidating mounts can change roll centre and tyre clearance; test setups incrementally and adjust spacer stacks to tune handling.

How do I protect the plate when clamping to metal stays?

Fit washers under screw heads, use threadlocker sparingly if needed, and avoid over-tightening to preserve the carbon fibre layup.

Is this plate suited to competitive tuning workflows?

Yes, the plate supports compact, repeatable roller positioning which can help with consistent handling and rapid setup changes during tuning.