Mini 4WD M2 x 6 Socket Button Screw - M4WD-19/BK by 3Racing  [M4WD-19/BK]

Tamiya Mini 4WD M2 x 6 Scoket Buttom Screw (black) - 3RACING M4WD-19/BK
Price:
USD$2.50
Brand:
3Racing
Model:
M4WD-19/BK
Condition:
Brand New
Write a review

M4WD-19/BK M2 x 6 socket button screw technical notes

This M2 x 6 socket button screw in black is intended as a service spare for 1/32 Mini 4WD assemblies that employ M2 fasteners. The button head profile provides a compact, rounded finish useful where head clearance and tidy mounting are required on standard Mini 4WD chassis.

Installation notes for tuners: confirm the M2 thread engagement and 6 mm length match the mating insert or nut. For repeat assembly cycles, inspect thread condition and head clearance to maintain consistent fit and avoid fatigue in thin panels.

Supplied as a single black M2 x 6 socket button screw listed under model M4WD-19/BK, this component is used primarily for replacements and small repairs within running setups rather than load-bearing modifications.

How do I confirm thread compatibility with an aftermarket insert?

Measure the existing fastener diameter and verify it is M2. Check available thread engagement depth and confirm 6 mm clearance to ensure secure clamping without bottoming out.

Are there recommended practices for repeated assembly?

Use the correct hex driver to avoid drive damage, avoid over-torquing, and inspect threads for wear. Replace damaged inserts to preserve repeatable torque and fitment.

Is the black finish indicative of material or coating information?

The black finish is listed as an appearance characteristic. If material specification or corrosion resistance is required for your application, request that information from the supplier prior to purchase.

Where is this screw typically used in a Mini 4WD setup?

Its low-profile head suits body fixings, accessory brackets and non-structural mounting points. Ensure the 6 mm length and M2 thread are correct for the location before fitting.