Mini 4WD Racing Tuning Cuboid 9g - M4WD-39/GO by 3Racing  [M4WD-39/GO]

Tamiya Mini 4WD cuboid Weight 9g -Gold - 3RACING M4WD-39/GO
Price:
USD$3.80
Brand:
3Racing
Model:
M4WD-39/GO
Condition:
Brand New
Write a review

M4WD-39/GO 9g cuboid damper for tuning and setup

A single-piece 9g cuboid weight finished in gold, supplied for Mini 4WD applications where compact, repeatable mass placement is required. The note emphasises component use and fit checks rather than performance guarantees.

The block geometry yields a concentrated inertial mass suitable for tight mounting locations. Its predictable centre of gravity makes it straightforward to use during iterative setup work and chassis tuning.

Verify compatibility with target chassis and mounting hardware prior to fitting. Installation commonly uses a dedicated slot or low-profile brackets and small fasteners; account for clearance around rollers and bumpers when planning placement.

No detailed material or dimensional specification is included here; treat the unit as a basic tuning accessory and confirm fitment during the setup process.

How does block placement affect handling?

Placement alters rotational inertia and front/rear weight bias. Move the block along the centreline for subtle pitch changes; lateral shifts will have a smaller effect on roll balance.

Recommended mounting for tuning sessions?

Use a secure but adjustable method such as a removable bracket or light screw fixings to trial positions quickly, then finalise with the preferred permanent fastener.

Can I use this with other damping systems?

Yes, it complements other dampers and weights, but combined mass distribution should be measured and tested to maintain consistent handling characteristics.

Any fit checks before competitive use?

Confirm clearance with bodywork, rollers and bumpers, and run a few test passes to validate that the added mass achieves the expected behaviour under race conditions.