Mini Inferno Front Suspension Holder MIF-025/BU technical mount by 3Racing  [MIF-025/BU]

Technical overview of the front mounting point

This front suspension holder is supplied for use on the Kyosho Mini Inferno chassis under the 3Racing MIF-025/BU designation and serves as the front suspension mounting interface for 1/18 scale Mini Inferno models. It is intended to provide a stable reference for alignment and shock positioning during precise setup work.

Fit and compatibility: designed to match Mini Inferno mounting patterns, but measure against your specific chassis variant to confirm hole spacing and shock eyelet clearance prior to full assembly. A trial fit avoids misalignment and interference with steering components.

Installation and setup notes: install following the original mounting footprint where possible, torque fasteners incrementally to maintain alignment, and recheck steering sweep and suspension droop after tightening. Use the holder to lock in front geometry during camber, toe and ride height adjustments for repeatable handling outcomes.

Tuning role: by stabilising the front suspension pick-up, the holder improves repeatability of shock positioning and wheel alignment, aiding consistent setup changes across different surfaces and session conditions.