Mini Inferno Front Upper Suspension Arm MIF-034/BU for Tuned Handling by 3Racing  [MIF-034/BU]

Kyosho Mini Inferno ACME NB16 Racing /Kyosho Mini Inferno Front Upper Suspension Arm - Blue Color - 3RACING MIF-034/BU
Price:
USD$8.80
Brand:
3Racing
Model:
MIF-034/BU
Condition:
Brand New
Write a review

Precision front upper arm for Mini Inferno setups

Engineered as a direct replacement for Kyosho Mini Inferno ACME NB16 Racing platforms, this blue front upper arm supports refined suspension geometry and consistent service life. It is designed for the RC front suspension assembly and aligns the hub carrier to shock and steering linkages.

Use the part to address wear or to adjust camber curves and initial steering behaviour as part of a competitive setup routine. Small, repeatable adjustments yield predictable handling changes when this arm is fitted.

Professional fitting and tuning advice

  • Ensure pivot bores and hinge pins are clean and free of burrs before final assembly to maintain predictable articulation.
  • Retain or replace bushings based on measured play; precision fit affects camber stability under load.
  • Log incremental geometry changes and measure cornering response to refine turn-in and mid-corner balance.
  • Torque hardware to manufacturer guidance and use the correct hex driver to prevent deformation of pivot interfaces.

What measurements change with a new arm?

Primary changes are camber curve and the lateral position of the hub carrier; measure static camber and track width before and after to quantify differences.

Which wear points should be inspected?

Inspect pivot bores, hinge pins and bushing surfaces for ovaling or scoring; any play at these points will degrade repeatability in setup.

Best practice for setup validation?

Validate handling with controlled test laps, change one variable at a time, and log steering response and lap times to identify beneficial adjustments.