Mini Inferno Rear Brace Stiffener MIF-015/TI by 3Racing  [MIF-015/TI]

Performance rear brace for Mini Inferno

The MIF-015/TI rear brace stiffener is engineered for Kyosho Mini Inferno and Mini Inferno ST chassis to increase rear section rigidity. Designed for racers and tuners, the component fits the factory rear brace points and offers a direct replacement profile without chassis modification.

Compatibility is constrained to the specified Mini Inferno variants and the piece uses the car's original mounting hardware. Confirm fitment and alignment before final torque to ensure consistent load paths through the rear assembly.

From a setup perspective, the unit changes how lateral and longitudinal loads are transferred to the suspension and differential, affecting traction and rotation. Tuning recommendations are to adjust dampers and tyre compounds in small steps while documenting lap-to-lap changes to isolate effects.

Installation procedure: prepare a clean work area, use precision hex drivers and small hand tools, retain factory fasteners when possible, inspect thread engagement on reassembly, and avoid excessive torque to maintain component integrity.