Mini Inferno Rear Suspension 1 Degree Holder MIF-026/BU by 3Racing  [MIF-026/BU]

Kyosho Mini Inferno /Kyosho Mini Inferno ST Rear Suspension Holder ( 1 Degree ) - Blue Color - 3Racing MIF-026/BU
Price:
USD$5.60
Brand:
3Racing
Model:
MIF-026/BU
Condition:
Brand New
Write a review

Precision rear mount for Mini Inferno tuning

The MIF-026/BU rear suspension holder is engineered as a direct-fit aftermarket component for Kyosho Mini Inferno and Mini Inferno ST chassis. It delivers a controlled 1 degree change to rear suspension geometry to assist in predictable handling adjustments during setup work.

Constructed to locate at the factory rear mounting points, this holder provides a single-angle solution for drivers focused on repeatable chassis behaviour. The blue finish identifies the part orientation and helps with quick visual checks when adjusting setups trackside.

Installation: remove the original holder, install this unit using the chassis standard fasteners, verify alignment and suspension travel before running, and perform a post-fit inspection after initial testing to confirm secure fitment.

What is the intended use case for the 1 degree offset?

The 1 degree offset is intended for precision tuning to affect roll centre and rear-end balance in small increments, useful when refining handling characteristics.

Are there any setup checks to perform after installation?

Verify wheel alignment, suspension clearance, and fastener torque after installation, then recheck after the initial running period to ensure dimensional stability.

Does this change require complementary adjustments?

Complementary tuning such as shock valving or anti-roll tuning may be considered, but the 1 degree holder is designed for subtle, standalone geometry correction.