Mini Inferno ST Rear Suspension Holder MIF-028/TI (3 Degree) by 3Racing  [MIF-028/TI]

Kyosho Mini Inferno ST Rear Suspension Holder (3 Degree) - 3RACING MIF-028/TI
Price:
USD$5.60
Brand:
3Racing
Model:
MIF-028/TI
Condition:
Brand New
Write a review

Technical summary

The MIF-028/TI rear suspension holder is an aftermarket replacement for the Kyosho Mini Inferno ST that fixes the rear assembly at a 3 degree cant. It is produced to align with Mini Inferno ST hub dimensions and changes the rear roll centre and load transfer characteristics for track tuning.

Installation procedure is consistent with standard Mini Inferno ST rear hub work: remove the OEM holder, transfer bearings and locating pins, then secure the replacement to the rear bulkhead using the original fasteners. No machining or adapter plates are required for compatible rear assemblies.

Performance notes: the 3 degree offset shifts static geometry to alter toe-in behaviour under lateral load and can increase rear traction on higher grip surfaces. Apply incremental adjustments to damper valving and anti-roll set-up when validating the change on the test track.

Is precise alignment needed during fitment?

Yes. Ensure bearings and locating pins are seated correctly and torque hardware to recommended settings to maintain accurate geometry and repeatable handling.

Should I expect changes to dynamic camber under load?

The 3 degree cant modifies how camber and toe evolve in roll. Reassess camber settings and damper tune to control mid-corner balance and tyre contact patch consistency.

Recommended setup workflow after fitting?

Start with baseline chassis settings, fit the holder, then make controlled changes: adjust rebound first, then bump and anti-roll bars, validating each change with short practice runs.