Mini-Z AWD Racing Toe Linkage 3 Degree Adjustment AWD-10/3 by 3Racing  [AWD-10/3]

Kyosho Mini-Z AWD Front Toe In_Out Linkage 3 Degree - 3RACING AWD-10/3
Price:
USD$3.80
Brand:
3Racing
Model:
AWD-10/3
Condition:
Brand New
Write a review

Competition grade front toe tuning for Mini-Z AWD

The AWD-10/3 front toe in/out linkage is a tuning component developed for Kyosho Mini-Z AWD platforms to give a precise 3 degree toe change. It is intended for drivers focused on setup refinement and predictable steering response under race conditions.

Use AWD-10/3 to incrementally adjust turn-in sharpness, mid-corner balance and exit traction on micro 1/27 scale race cars. The part mounts as a direct replacement in the Mini-Z AWD front steering assembly and integrates with standard steering arms and attachment points for straightforward setup changes.

Installation is aimed at experienced racers and tuners: confirm clean seating in knuckles and rod ends, check dynamic clearance with wheel hubs, and perform bench steering travel checks after fitting. Fine adjustments can be made trackside with small hex tools and measured toe gauges for repeatable setup data.

Is AWD-10/3 suitable for competitive Mini-Z AWD setups?

Yes. AWD-10/3 offers a calibrated 3 degree change intended to help drivers fine tune handling without altering suspension geometry.

How should tuners verify toe settings trackside?

Use a small toe gauge or measured bench setup, confirm wheel alignment after small increments, and log changes for consistent lap-to-lap comparison.

Any recommended pre-race checks after fitting?

Verify all ball joints are tight, check for binding at full steering sweep, and perform a staged track run to assess turn-in, mid-corner balance and exit behaviour.