Mini-Z AWD Tuning Stabilizer Links AWD-37 by 3Racing  [AWD-37]

Technical overview for Mini-Z AWD stabilizers

This front and rear stabilizer link set is intended for Kyosho Mini-Z AWD platforms and carries the identifier AWD-37. The links act as chassis-level tuning components to modify roll stiffness and lateral balance for refined handling in close-quarters racing.

Supplied as direct bolt-in replacements for factory stabilizer links and mounts, the design focuses on simple fitment and predictable geometry changes rather than additional mounting hardware. The result is a controlled method to alter transient response and mid-corner balance without affecting drivetrain settings.

Installation is performed at the Mini-Z AWD chassis stabilizer attachment points and uses the car's original mounting locations. Standard hobby tools are sufficient; pay attention to alignment, secure fasteners and inspect link articulation after initial runs.

Practical tuning workflow: adjust link length or stabilizer geometry in measured increments, log each iteration and evaluate changes on a consistent surface. Seek balance between front and rear to prevent one-end dominance and aim for repeatable handling characteristics at race pace.

Fitment details

• Kyosho Mini-Z AWD
• MR-03 AWD series