Mini-Z F1 Precision 0 Degree Front Toe Link MKF-02/0 by 3Racing  [MKF-02/0]

Technical summary of front toe linkage

This front toe in/out linkage is produced for KYOSHO Mini-Z F1 chassis and supplied as the MKF-02/0 replacement unit. It sets a fixed 0 degree toe at the front to establish a neutral baseline for steering geometry during setup or component validation.

Compatibility covers Mini-Z F1 variants that share the front linkage mount standard used on KYOSHO Mini-Z F1 models. The part is engineered as a direct-fit spare or as an alternative to OEM linkage when a consistent 0 degree reference is required for comparative tests or tuning iterations.

Installation guidance: remove the existing front linkage per the chassis manual, inspect ball studs and steering posts for wear, and fasten with the original hardware. Use the chassis' toe adjusters or alternate-length tie rods to vary toe settings, ensuring left/right symmetry and freedom from binding.

Tuning application: using a 0 degree front linkage delivers a neutral steering reference that simplifies evaluation of suspension, roll and tyre behaviour without toe-induced bias. Swap to measured angled linkages to quantify toe-in and toe-out impact on corner entry and mid-corner balance.

As a dedicated replacement, this linkage supports repeatable baseline setup, spare provisioning, and controlled tuning work on Mini-Z F1 chassis with the KYOSHO standard front interface.