Mini-Z MR-01 Camber Steering Block KM-018 1, 2 and 3 deg technical upgrade by 3Racing  [KM-018]

Technical camber block for Mini-Z MR-01

The KM-018 is a dedicated camber steering block for Kyosho Mini-Z MR-01 chassis that provides three fixed camber positions at 1, 2 and 3 deg. This component permits repeatable adjustments to front wheel inclination while leaving other suspension hardware unchanged, useful for precise handling development on small-scale tracks.

Compatibility is limited to the Mini-Z MR-01 platform; install the KM-018 as a direct replacement for the factory steering block following standard chassis service procedures. Each camber setting shifts hub geometry and will affect cornering load distribution and steering feedback in measurable steps.

Installation procedure: remove the MR-01 front hubs and steering knuckles as required, transfer bearings and retaining pins into the KM-018, and torque the original fasteners to the usual specification. After assembly, inspect for binding and verify smooth control through full steering and suspension travel.

Application guidance: use the KM-018 to incrementally alter static camber for tyre contact optimisation on carpet or layout surfaces and to refine turn-in characteristics without modifying spring rates. Implement small changes and log results to build a repeatable tuning map.