Mini-Z MR-02/MR-015 Racing 0 Degree Steering Block KZ-08/0/TI by 3Racing  [KZ-08/0/TI]

Kyosho Mini-Z MR-02 (MM) /Mini-Z MR-015 Aluminium Steering Block( 0 Degree ) - Titanium Color - 3Racing KZ-08/0/TI
Price:
USD$10.00
Brand:
3Racing
Model:
KZ-08/0/TI
Condition:
Brand New
Write a review

Racing steering block for Mini-Z MR chassis

Precision-machined titanium-colour aluminium steering block designed to replace the stock plastic unit on Kyosho Mini-Z MR-02 (MM) and MR-015. The rigid mounting point reduces knuckle movement and helps preserve steering geometry under race loads.

Setup intent: this component is aimed at drivers who require predictable front-end response and repeatable toe and caster settings for competitive running. It reduces compliance that can mask fine tuning changes.

Fitting and hardware: the block installs to the original steering assembly mounting points. Verify fastener condition, use correct torque for aluminium parts and confirm there is no interference with the suspension or servo horn during full steering travel.

Service recommendations: inspect for deformation or burrs after crashes and replace damaged fasteners promptly. Regular cleaning and torque checks will keep handling consistent through event weekends.

What is the main race benefit?

The primary benefit is a more stable steering anchor that improves repeatability of small setup changes, aiding consistent corner entry and improved lap-to-lap performance.

Are thread inserts recommended?

For high-use race cars consider using helicoils or properly sized steel inserts where repeated assembly is expected, otherwise monitor aluminium threads and avoid over-torquing.

What setup changes might be needed after fitting?

Drivers may find steering feels crisper; recheck toe and caster settings and perform a short test session to fine tune steering endpoints and servo-saver interaction.