Mini-Z MR-03 AWD Race-Tuned Toe Link 1 Degree - AWD-10/1 by 3Racing  [AWD-10/1]

Kyosho Mini-Z AWD Front Toe In / Out Linkage 1 Degree - AWD-10/1
Price:
USD$3.80
Brand:
3Racing
Model:
AWD-10/1
Condition:
Brand New
Write a review

Race-focused front toe linkage for Mini-Z AWD

This 1 degree stepped toe in/out linkage is engineered for fine front-end geometry adjustments on Kyosho Mini-Z MR-03 AWD chassis. As an aftermarket tuning component it lets competitive drivers make precise, repeatable toe changes to optimise turn-in and mid-corner balance on indoor circuits.

At the scale level, incremental toe adjustments influence initial steering response, transient behaviour and straight-line tracking. Use this link during setup sessions to methodically evaluate handling, logging each step to build a consistent baseline between runs.

Installation requires standard Mini-Z front-end access. Remove the original linkage, fit this unit with the vehicle's factory fasteners and torque to recommended snugness. Verify wheel alignment at ride height and check for binding; make changes in single-degree steps and validate on a consistent surface to isolate the effect of each adjustment.

Which MR-03 subtypes are compatible?

This part is for Kyosho Mini-Z vehicles that use the MR-03 AWD platform. Confirm chassis designation before installing.

How should I log setup changes?

Record baseline toe, make single 1 degree changes, then run multiple consistent laps and note effects on lap time, turn-in and mid-corner balance to build a tuning map.

Any fitment checks to perform?

After fitting, confirm there is no steering bind, verify clearance at full suspension droop and check wheel alignment at ride height before track testing.