Mini-Z Race-Oriented 1 Degree Aluminium Steering Block KZ-08/1/BU by 3Racing  [KZ-08/1/BU]

Kyosho Mini-Z MR-02 (MM) /Mini-Z MR-015 Aluminium Steering Block( 1 Degree ) - Blue Color - 3Racing KZ-08/1/BU
Price:
USD$10.00
Brand:
3Racing
Model:
KZ-08/1/BU
Condition:
Brand New
Write a review

Race-focused aluminium steering block

This blue aluminium steering block is produced as a direct-fit upgrade for Kyosho Mini-Z MR-02 (MM) and MR-015 platforms named in the title. The part sets steering at 1 degree and replaces the stock plastic unit to reduce compliance and better translate servo input to the wheels.

Compatibility is limited to the chassis codes noted in the title; confirm your Mini-Z model prior to installation. The aluminium body provides a stiffer mounting surface compared with original plastic parts and is intended for club and competitive Mini-Z environments where repeatable steering response matters.

Install by removing the original steering block and refitting this unit using the existing mounting points and fasteners. The component is designed for tuning steering geometry and feel without requiring additional suspension modification, allowing precise corner entry adjustments for lap time improvements.

What tuning effect does 1 degree deliver?

A 1 degree change slightly shifts steering geometry to tighten initial turn-in and reduce understeer tendency on entry, useful for fine setup balance on carpet and hard surface tracks.

Does aluminium affect servo load?

Aluminium increases stiffness at the mounting point but does not significantly change servo torque needs; ensure linkage alignment is correct to avoid extra binding.

Recommended checks after fitting?

After installation, verify steering centring, ensure no binding through the travel, and retorque mounting screws after a short break-in run to maintain consistent geometry.