MTX-4 Racing 52T Delrin Spur Gear MTX4-0852/V2 by 3Racing  [MTX4-0852/V2]

Mugen Seiki MTX4 Low Friction Delrin Supr Gear 0.8 Pitch 52T Version 2 - 3RACING MTX4-0852/V2
Price:
USD$2.30
Brand:
3Racing
Model:
MTX4-0852/V2
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Performance-Focused MTX-4 Delrin 52T Spur

This Version 2, 0.8 pitch 52-tooth spur is manufactured in Delrin for MTX-4 scale drivetrains where low friction and consistent tooth geometry are required. The material choice reduces sliding resistance and can improve drivetrain efficiency when matched with correct pinion materials and setup.

Intended as a direct-replacement unit, install into compatible MTX-4 gearboxes following standard alignment procedures. Verify gear mesh under no-load rotation, remove any molding flash, and confirm free running before load testing to protect bearings and pinion teeth.

For Version 2 units, focus on true concentric alignment and secure gearbox cover retention to maintain repeatable mesh under competition use.

How do I achieve optimal mesh for racing?

Start with motor mounting shims to set a slight backlash, then verify smooth rotation at low speed. Minor adjustments to motor position will fine tune engagement for minimal noise and friction.

What inspection points reduce failure risk?

Check for molding flash, ensure teeth are uniform, confirm pinion compatibility, and inspect bearings and shafts for endplay that could alter mesh under load.

Is Delrin suitable for high-power setups?

Delrin offers low friction and good wear properties, but for very high torque systems monitor wear and consider steel or hardened options if sustained torque causes accelerated deterioration.