MTX4 Racing Delrin 60T Spur Gear 0.8 Pitch MTX4-0860/V2 by 3Racing  [MTX4-0860/V2]

Mugen Seiki MTX4 Low Friction Delrin Supr Gear 0.8 Pitch 60T Version 2 - 3RACING MTX4-0860/V2
Price:
USD$2.30
Brand:
3Racing
Model:
MTX4-0860/V2
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Precision Delrin 60T spur for MTX4 setups

Purpose-built replacement spur for Mugen Seiki MTX4 gearboxes, supplied as part MTX4-0860/V2 by 3Racing. The Delrin 60T 0.8 pitch design targets minimal rotational drag and repeatable tooth engagement for competitive on-road tuning.

Application brief: intended as a direct service item or tuning component for MTX4 platforms that require a 0.8 pitch 60-tooth spur. Confirm gearbox specifications before installation and match the pinion pitch and tooth count to retain optimal mesh and drivetrain reliability.

Installation and setup protocol: install on a clean spur hub, verify spline seating and axial runout, and set pinion backlash to the tight tolerance appropriate for your setup. While fitting, inspect bearings and drive alignment and use threadlocker only where specified by the chassis guidance.

Technical note: Delrin offers predictable wear and low friction under typical racing loads, helping preserve drivetrain response during tuning cycles and race day checks.

Which pinion specifications should be used?

Use a pinion that matches 0.8 pitch and select tooth count based on the desired final ratio; maintain correct mesh to prevent premature tooth wear.

How to check mesh under load?

Rotate the drivetrain under light load and observe engagement across the tooth face; adjust pinion spacing until contact is even with minimal clearance under load.

What does MTX4-0860/V2 indicate?

MTX4-0860/V2 is the supplier part number and revision. Confirm this exact code to ensure the correct item is used for your MTX4 gearbox application.